ProxyMag AK-74M/101 Tanker Magazine

ProxyMag AK-74M/101 Tanker Magazine: Laffs Dynamics 3D printed dual caliber AK platform magazine for use in AKs chambered in 5.45x39, or 5.56x45 NATO. Caliber changes are quick via swapping out the follower. Floorplate, baseplate, locking tab, and magazine body are the same between calibers. Has the same strong, separately printed locking tab used in the Waco Waffle and Slabslav series of Laffs Dynamics AKM magazines. This is the 20rd "Tanker" variant of the original Laffs Dynamics 30rd ProxyMag. (Check notes for link to original file.) Weapons Tested In: 1x WBP Mini Jack 5.56 AK Pistol (Polish Import) 1x M+M M10 5.45 AK Rifle (Romanian Import) 1x PSAK-74 AK Rifle (American Production) Recommended Print Settings: Filament Used: PLA+ Print Settings: Extruder: 220C Bed: 56C First Layer Print Height: .2mm Standard Layer Height: .16mm (.12mm for the Follower & Locking Tab) Wall Thickness: .40 Wall Perimeters: 8 Infill: 80%+ Support Material Percentage: 18% Hardware: 1x Original AK-74 mag spring, Beryl mag spring, or listed compatible mag spring. (See Notes) Epoxy or Clear Gorilla Glue Parts Installation: 1) Apply cyanoacrylate adhesive inside the pocket for the rear locking lug. If the rear locking lug is slightly loose in the pocket, apply Clear Gorilla Glue. Wait 24hrs for the adhesive to cure. 2) Insert the rear locking lug, with the angled facet facing outwards and down towards the mag body's base. 3) Lightly sand the anti-friction follower's sides and curved spine. 4) Slide the top of the magazine spring through the front of the follower, above the spring retention tab. 5) Attach the floorplate to the bottom of the magazine spring, making sure the first spring winding snaps over the retainers. 6) Slide the internal spring assembly into the magazine body. 7) Depress the floorplate, and slide on the baseplate. The floorplate's locking tab must index with the channel in the baseplate. Notes: 1) Polish Beryl, WBP- 5.56/223, Promag AK-74, and Wolff mag springs are compatible with this magazine. 2) Polish Beryl follower was tested and works in the printed mag body, but the bottom-most round may be loosely held in place. 3) Testing concluded you can use a standard 30rd length, standard pressure mag spring and still load safely 20rds. Its still advised you cut down springs to 20rd lengths, but it is not required. 4) The original 30rd ProxyMag can be found here: https://odysee.com/@LFM:f/ProxyMagAK74:5 LBRY Tags: 3d printing; firearms; ak; tanker; magazine; c:disable-slimes-comments; c:disable-slimes-video; c:disable-reactions-comments; c:disable-reactions-video