17LLLLLLLLLLLLLLLLLLLLLLLL

CHAIRMANWON 17LLLLLLLLLLLLLLL ------------------------------------------------------------------- Requires a 11lb recoil spring, the following comp, and a 17L slide w/ threaded barrel Comp Listing https://www.ebay.com/itm/135010541410 ------------------------------------------------------------------- Files are licensed under GPL2 AKA feel free to use these files for any propose (including commercial) but you have to attribute them to me and any derivatives must be released under the same license if you release it. ------------------------------------------------------------------- BTC donation address 3QE1kvedKH79Xr3wKZ7nT9hnt7h8LjKh3Q ------------------------------------------------------------------- Printing Profile Notes Support X/Y Distance: 1.3mm (stops Cura from supporting stipples) Use tree supports instead of normal supports (if you are suffering from very long slice times switch back to normal supports, you will waste material compared to trees but the print will be fine) Enable Z hop on retract If you are using Prusa Slicer make sure you have Detect Thin Walls set to off Nozzle: 0.4mm Layer Height: 0.16mm Temp: 215-230/60C Infill: 100% Walls: 8 Supports: On/full - use a close support interface gap. Your interface gap should not be larger than 0.15mm unless you know what you are doing with your setup. Cooling fan: 20% normal, 50% on bridges. Off for the first 3 layers. Keep the fan low to prevent warp. All other settings can/should be left as default or whatever you know works best with your printing setup.